Hackerspace scanner, the laser cut version

Built a scanner? Started to build a scanner? Record your progress here. Doesn't need to be a whole scanner - triggers and other parts are fine. Commercial scanners are fine too.

Moderator: peterZ

qv_
Posts: 39
Joined: 01 Jul 2014, 17:33
E-book readers owned: iRiver
Number of books owned: 1000
Country: Sweden
Location: Sweden, Södermanland

Re: Hackerspace scanner, the laser cut version

Post by qv_ »

I did not get access of a CNC cutter to a desent cost.... So I use the drawing "as is" on the laser cutter.

The hole for the bearing was a bit big and the wood is "burn" and smell in the beginning.

I also need to change some things there the CNC cutter only cut part of the deep.

If I could get hold of a CNC cutter to a nice cost I use that next time.

/Jan
qv_
Posts: 39
Joined: 01 Jul 2014, 17:33
E-book readers owned: iRiver
Number of books owned: 1000
Country: Sweden
Location: Sweden, Södermanland

Re: Hackerspace scanner, the laser cut version

Post by qv_ »

Not yet ready, but soon.....

I have spent the last 1 ½ year building a new work shop, Then I have time for this again.
IMG_3197.JPG
I will be back.
Post Reply