Page 28 of 28

Re: Scan Tailor "Experimental"

Posted: 29 Apr 2018, 12:46
by Tulon
tomse,

Unfortunately, I don't see myself working on Scan Tailor again. It's been a while since I touched it the last time, and I never felt like going back to it since.

Re: Scan Tailor "Experimental"

Posted: 30 Apr 2018, 09:27
by tomse
nevertheless, your work is much appreciated, a big thank you is the least I can give you :-)

Re: Scan Tailor "Experimental"

Posted: 04 May 2018, 11:03
by antwoorden
Tulon, I've registered here just to say THANKS for your awesome work on Scan Tailor Experimental.
I'm using it both in GUI and CLI (which works only when you define all steps!), and it's awesome that I don't have to enter input DPI anymore.
I love the new feature to adjust 'curved lines'. It's near perfect! Great work.

Re: Scan Tailor "Experimental"

Posted: 07 May 2018, 00:49
by Tulon
antwoorden, I am glad you found Scan Tailor Experimental useful.

It's surprising the CLI mode worked for you at all, as I remember it was seriously broken in the Experimental version.
As for "adjusting curved lines", that feature was present in earlier versions as well, on the Output stage under the "Dewarping" tab.

Re: Scan Tailor "Experimental"

Posted: 07 May 2018, 07:34
by antwoorden
Tulon, as foler mentioned before, CLI mode isn't broken at all. You just have to define: "--end-filter=6" so it won't stop at step 4. It should be easy for you as the developer, to set 6 as default again.

Re: Scan Tailor "Experimental"

Posted: 11 Dec 2018, 11:11
by antwoorden
I really hope Tulon will work on this again... it's almost perfect!
On pages with just a few lines of text the curved lines dewarping messes things up...
And the accuracy of it could be just a little bit better.
Other than that: perfect!